8.1 Run Model Analysis

To analyze a model, select an active model from the Model List then click Run Analysis in the left-hand navigation.

You will be presented with a set of analyses designated by the modeler when preparing the model for sharing. If no analyses were designated, a set of default analyses will be presented.

Click one of the analysis buttons seen above to run the analysis. When the analysis is finished, results will be presented for viewing.

The above figure shows two sets of analysis results in the left panel - CEA Graph & Rankings WTP 50K and Markov Cohort - Tx 1. To the right, you see the selected analysis CEA Graph & Rankings WTP 50K.

For CEA Graph & Rankings WTP 50K. Analyses, you see two visible outputs - Cost-Effectiveness Graph and Rankings. Click on either to see the related output.

The expanded Analysis details on the right hand side provides details on the analysis - status, model, run date/time, etc.

Subsequent sections in this chapter describe each analysis type supported by TPWeb.